|
Description:
|
SunStone®
Pearl finishes are blends of specially selected pebble aggregate and
fortified white Portland cement SunStone® Pearl combines the proven
durability of pebble finishes with the increased smoothness of smaller
pebble aggregates. Color fast ceramic pigments offer the customer
almost limitless flexibility in poolscape design. Ideal for residential
or commercial projects, SunStone® Pearl is easily installed but
intended for use by professional applicators. |
|
Benefits:
|
-
Unsurpassed Proven durability
- Extremely etch resistant
- Colorful, variegated aggregates
- Traditionally or spray applied
- Ease of Maintenance |
|
Preparation:
|
SunStone®
Pearl should be applied to a sound surface free of oil, dirt, algae
or any other foreign substance. Previously applied paints or sealers
must be removed by acid washing and/or sandblasting. Neutralize acid
with baking soda or soda ash then thoroughly rinse with water. In
addition to, or in partial replacement of, the procedures mentioned
above, a scratch coat such as CLI PermaKote® could be used as
a bond coat. Re-finished pools must be undercut an appropriate distance
around all tile, return lines, light fixtures and main drains. All
weepers and plumbing leaks should be repaired at least 24 hours prior
to plaster application. |
|
Mixing:
|
1.
Using standard mixing equipment, it is important to blend each batch
for the same amount of time.
2. Mix SunStone® Pearl with approximately 1 1/4 to 1 1/2 gallons
of potable water per 80-lb. bag.
3. Start the mixing procedure by adding approximately 2/3 of the total
water requirements to the mixer, add SunStone Pearl™ and then
the balance of the water.
4. Mix the complete batch for at least 8 minutes to ensure a proper
blend of all ingredients and coverage rates per bag. If application
must be interrupted, finish to a natural break to prevent joints from
showing. SunStone Pearl™ should be applied in temperatures exceeding
40†F. |
|
Curing:
|
Care
should be taken to protect SunStone® Pearl from rapid drying conditions
such as high wind, high temperature, low humidity. Such precautions
may include fogging or misting the surface or placing a protective
covering over the pool. Cover should not be placed directly on pool
surface. |
|
Filling
Procedures:
|
When
filling a pool it is important to do so without interruption of fill
water. Fill pool as rapidly as possible. All fill hoses should have
a sock or cloth on the end. Do not allow main hose length to lay on
the plaster surface, as it will leave a mark. |
|
Water
Chemistry:
|
The
pool water must be carefully balanced from the initial fill and constantly
maintained within NSPI recommended guidelines. Maintaining proper
chemical balance from first fill is essential to maximize the life
of the pool surface. Please consult your CLI Product Service Representative
concerning start-up techniques and maintenance programs. |
|
Coverage:
|
Each
80-lb. bag covers approximately 18-22 sq. feet at 3/8" thickness.
Coverage rates may vary depending on method of application and condition
of substrate. |
|
Packaging:
|
SunStone®
Select is packaged in 80-lb. heavy-duty poly-lined bags. |
|
Warnings:
|
Product
is alkaline on contact with water. During mixing or application, avoid
contact with eyes or skin. In case of such contact, flood eyes repeatedly
with water and call physician. Do not take internally. Wear NIOSH
approved mask during mixing procedures. |