|
Description:
|
SunStone
Select finishes are blends of specially selected quartz and other
aggregates, fortified white Portland cement and colored quartz accents.
SunStone Select combines the proven durability of exposed aggregate
finishes with the smoothness of traditional pool plaster. SunStone
Select’s variety in color and texture offers the customer almost
limitless flexibility in poolscape design. Ideal for residential or
commercial projects, SunStone Select is easily installed but intended
for use by professional applicators. |
|
Benefits:
|
-
Proven durability
- Extremely etch resistant
- Smooth finish
- High density of colored aggregate
- Traditionally or spray applied
- Ease of Maintenance |
|
Preparation:
|
SunStone
Select should be applied to a sound surface free of oil, dirt, algae
or any other foreign substance. Previously applied paints or sealers
must be removed by acid washing and/or sandblasting. Neutralize acid
with baking soda or soda ash then thoroughly rinse with water. In
addition to, or in partial replacement of, the procedures mentioned
above, CLI PermaKote™ could be used as a bonding coat. Re-finished
pools must be undercut an appropriate distance around all tile, return
lines, light fixtures and main drains. All weepers and plumbing leaks
should be repaired at least 24 hours prior to plaster application. |
|
Mixing:
|
1.
Using standard mixing equipment, it is important to blend each batch
for the same amount of time. Box different number batches.
2. Mix SunStone Select with approximately 1 1/2 to 1 3/4 gallons of
potable water per 80-lb. bag.
3. Start the mixing procedure by adding approximately 2/3 of the total
water requirements to the mixer, add SunStone Select and then add
the balance of the water.
4. Mix the completed batch for at least 8 minutes to ensure a proper
blend of all ingredients.
5. Before using any job site additives, please consult your CLI Product
Service Representative. |
|
Application:
|
SunStone
Select may be applied by either spray or conventional methods. Apply
SunStone Select over a lightly dampened (no standing water) surface
to a uniform thickness of approximately 3/8." Substrate conditions
will have a direct relationship on the thickness of application and
coverage rates per bag. If application must be interrupted, finish
to a natural break to prevent joints from showing. SunStone Select
should be applied in temperatures exceeding 40†F. After the finish
has sufficiently hardened, usually several hours, a dilute muriatic
acid solution and brushing are used to remove the cement film from
the aggregate surface. Sodium Bicarbonate is placed around the bowl
to prevent over-exposing this area. |
|
Curing:
|
Care
should be taken to protect SunStone Select from rapid drying conditions
such as high wind, high temperature, low humidity. Such precautions
may include fogging or misting the surface or placing a protective
covering over the pool. Cover should not be placed on the plaster
surface. |
|
Filling
Procedures:
|
When
filling a pool it is important to do so without interruption of fill
water. Fill pool as rapidly as possible. All fill hoses should have
a sock or cloth on the end. Do not allow main hose length to lay on
the plaster surface as it will leave a mark. |
|
Water
Chemistry:
|
The
pool water must be carefully balanced from the initial fill and constantly
maintained within NSPI recommended guidelines. Maintaining proper
chemical balance from first fill is essential to maximize the life
of the pool surface. Please consult your CLI Product Service Representative
concerning start-up techniques and maintenance programs. |
|
Coverage:
|
Each
80-lb. bag covers approximately 20-25 sq. feet at 3/8" thickness.
Coverage rates may vary depending on method of application and condition
of substrate. |